Arthur_Martin AGH6343LOX Uživatelský manuál stáhnout pdf (Strana 13)

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

A

5.

If you change:

• from natural gas G20/G25 20/25

mbar to liquid gas, fully tighten the

bypass screw in.

• from liquid gas to natural gas

G20/G25 20/25 mbar, undo the

bypass screw approximately 1/4 of a

turn (1/2 of a turn for Multi Crown

burner).

WARNING! Make sure the

flame does not go out when you

quickly turn the knob from the

maximum position to the

minimum position.

Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a

correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the appliance

is in connection with an extension cable,

an adapter or a multiple connection.

Make sure that the ground connection

agrees with the standards and

regulations.

• Do not let the power cable to heat up to

a temperature higher than 90° C.

Make sure that you connect the

blue neutral cable to the terminal

with a letter "N" on it. Connect

the brown (or black) phase

cable to the terminal which has

a letter "L". Keep the phase

cable connected at all times.

Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H03V2V2-FT90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth wire

must be approximately 2 cm longer than

the brown (or black) phase wire.

Assembly

1.

13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Komentáře k této Příručce

Žádné komentáře