Arthur_Martin AKG933A7OX Uživatelský manuál stáhnout pdf (Strana 9)

BEFORE FIRST USE

WARNING! Refer to Safety

chapters.

Initial Cleaning

Remove all accessories and removable

shelf supports from the oven.

Refer to "Care and cleaning"

chapter.

Clean the oven and the accessories

before first use.

Put the accessories and the removable

shelf supports back to their initial position.

Setting the time

You must set the time of day before you

operate the oven.

When you connect the appliance to the

electrical supply or after a power cut, the

display shows 0:00.

1. Press at the same time the and

buttons.

Hold the buttons until 0:00 flashes on the

display.

2. Press the or button to set the

time of day.

After approximately five seconds, the

flashing stops and the display shows the

time you set.

Preheating

Preheat the empty appliance to burn off

the remaining grease.

1. Set the maximum temperature.

2. Let the appliance operate for

approximately 1 hour.

WARNING! Accessories can

become hotter than usual.

The appliance can emit an odour and

smoke. This is normal. Make sure that the

airflow is sufficient.

Let the oven cool down. Dampen a soft

cloth with warm water and a little mild

washing-up liquid and use this to clean the

oven cavity.

HOB - DAILY USE

WARNING! Refer to Safety

chapters.

Ignition of the hob burner

Always light the burner before

you put on the cookware.

WARNING! Be very careful

when you use open fire in the

kitchen environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

The spark generator can start

automatically when you switch

on the mains, after installation

or a power cut. It is normal.

In the absence of electricity you

can ignite the burner manually.

Ignition of a hob burner with the

thermocouple

• For manual ignition put the flame near

the burner. Push the knob for the hob

down and turn it counterclockwise to

the maximum gas flow position

.

• For integrated ignition on knob push

the knob for the hob down and turn it

counterclockwise to the maximum gas

flow position .

Keep the knob for the hob pushed for

equal or less than 10 seconds to let the

thermocouple warm up. If not, the gas

supply is interrupted.

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Komentáře k této Příručce

Žádné komentáře